Canon Ir Error Code List. Code Description. E Communication error ( with pedestal). E Communication error (with ASSIST). Free downloads Error Codes Canon iRPage 1 of 5 Error Codes Canon iR Download here the full version of service manual iR Code List. Thank you for purchasing the Canon iR/iR/iR Series Machine. This Manual describes the use of the List of Error Codes Without Messages.
|Published (Last):||11 November 2014|
|PDF File Size:||11.44 Mb|
|ePub File Size:||16.97 Mb|
|Price:||Free* [*Free Regsitration Required]|
Main cause The connector has poor connection. Replace the options power supply PCB. E When the power switch of the host machine is turned on, the back-up data from the EEPROM cannot be read or the data that has been read has a fault.
The option power supply PCB is faulty. Replace the rear controller PCB. Connector Is the printer board accessory connected correctly?
The paddle motor M2 is faulty. The code may be checked in service mode: Categories Blog Manuals Service Specification. Is it 0 W short circuit?
Wiring Is the wiring from the scanning lamp to the reader controller PCB normal? Replace the main controller PCB. The card reader PCB is faulty. Main cause The waste toner case is full. Action Ccodes PCI slot may be disabled in service mode to prevent the error: Main cause The wiring is faulty short circuit, open circuit.
Canon Ir 3300 Error Code List
Malfunction, Lisg Turn off and then on the main power switch. Main cause The feed motor M1 is faulty. The delivery tray paper height sensor S10 is faulty, the harness is disconnected, or an open circuit exits.
After replacement, be sure to enter the service mode data newly. The host machine can still generate copies if the finisher cable is disconnected and cannon delivery path is set to the delivery tray of the host machine.
Canon IR Error Code List – Copy Care Enterprise
The front aligning plate home position sensor S6 is faulty. Connect the wiring and the connectors. If the fixing film is normal, replace the sensor.
Caution When this code occurs, no code is indicated, but the keys are locked. Correct the wiring and the connection.
The thermistor control mechanism is faulty. Main cause The puncher home position sensor PI1P is faulty.
Canon IR 3300 Error Code List
Wiring, Connector Are the wiring and connector of the fan normal? E The PCI bus has a fault. The home position sensor does not eerror ON when the main power switch is turned on. E The feeding roller does not leave home position when the feed motor is driven for 2 sec.
Error Codes > Canon > iR > page 7
Is the drive voltage of the heater supplied by the connector J8 of the main power supply PCB? Replace the fixing motor. Is the problem corrected? Action If this error occurs during normal copying or printing, the job in question image data srror cleared when the main power switch is turned off and then on again; i.
The aligning plate home position sensor rear; PI5 is faulty.